The "Solid Carbon" technology is the most classic and most tried technology for producing frame structures in carbon. The result is a component, manufactured in just one stage, without any other mountings or procedures and without interruptions to the carbon fibers that can in this way fully enable all their qualities. The carbon fibers are high module (HM) and high resistance (HR), assembled in standard sized moulds and consolidated in high pressure autoclave employing the ìsackî technique. The interweaving and the quality of the fibers are varied and reinforcements in kevlar are also applied to the most critical parts in order to increase the mechanical resistance and optimize strength, stiffness and low weight. The new generation RC2 wishbone is applied to the front monocoque frame and is also used with the Estremo and Ulisse series. The production of components using moulds allow us to attain high quality with complete control over the consolidation of the materials. We take great care of the finish and maintain a moderate cost. Frames are spray-painted by hand and use a full carbon Speedcarbon fork.